正己烷
![]()
-
標準物質/乙腈中吡蚜酮
BePure-25305XA-1.2mL | 100μg/mL
-
標準物質/乙腈中烯酰嗎啉
BePure-22145XA-1.2mL | 100μg/mL
-
標準物質/乙腈中甲霜靈
BePure-23919XA-1.2mL | 100μg/mL
-
標準物質/乙腈中氟啶胺
BePure-22943XA-1.2mL | 100μg/mL
-
標準物質/乙腈中戊唑醇
BePure-25751XA-1.2mL | 100μg/mL
Reference Material
This certificate is designed in accordance with ISO 17034 and ISO Guide 31. This reference material (RM) was designed,produced and verified in accordance with ISO/IEC 17025, ISO 17034 and a registered quality management system ISO9001.
Product Name
n-Hexane
Product Code
BW901023
Lot Number
23041531
CAS No.
110-54-3
Mol. Formula
C6H14
Mol. Weight
86.18
Certified on
18 Apr 2023
Expiry Date
17 Apr 2025
Storage Temp
(0~4)°C
Specification
0.5 mL
CERTIFIED
Purity
CERTIFIED
Expanded Uncertainty (U)
Approved by
98.5%
0.5%
Uncertainty
The certified value(s) and uncertainty(ies) are determined in accordance with ISO 17034 with an 95% confidence level (k=2). Uncertainty is based on the Total Combined Uncertainty, including uncertainties of characterisation, homogeneity and stability testing. Stability values are based on real evidence opposed to simulation.
The producer certifies that this reference material meets the specification stated in this certificate until the expiry date, provided it is stored unopened at the recommended temperature herein. Product warranties for this reference material are set out in the terms and conditions of purchase.
Intended Use
This RM is intended for use in a laboratory as a calibration and quality control standard or in method development for analytical techniques.
Safety
Proper precautions should be observed while handling. See Safety Data Sheet.
Traceability
The balances used for gravimetric measurements are calibrated with weights traceable to the national standards (DKD). The calibration of the balances is verified daily internally and annually by an external accredited calibration service. Chromatographic methods are traceable to the International System of Units (SI).
Homogeneity
Random replicate samples of the final packaged RM have been analysed to prove homogeneity compliant with ISO 17034.
Storage
The RM should be stored in the original sealed container at the indicated temperature.
Instructions for use
It is recommended to use 1 mg as the minimum sample size and if less material is used, to increase the certified uncertainty by a factor of two for half sample and four for a quarter of sample. If storage after opening is necessary, the RM should be tightly closed and kept from light and moisture. If the RM was in a sealed ampoule, it should be transferred to a vial with minimum head space.
您正在瀏覽的產品：正己烷
手機版：正己烷
本公司銷售的所有產品僅供實驗科研使用，不用于人體及臨床診斷。
GBZ/T 160.41-2004《工作場所空氣有毒物質測定 烷烴類化合物》
本標準適用于工作場所空氣中正己烷的濃度檢測，包括車間、實驗室等職業衛生環境中的短時間接觸容許濃度（STEL）和時間加權平均濃度（TWA）測定。
采用活性炭管采集空氣樣品，經二硫化碳解吸后，使用氣相色譜-氫火焰離子化檢測器（GC-FID）進行定量分析。色譜柱推薦使用毛細管柱（如HP-1或等效型號）。
方法檢出限為0.05 μg/mL，定量限為0.2 μg/mL。采樣體積按10 L計，最低檢測濃度為0.5 mg/m3。
每批次樣品需包含空白對照、加標回收樣品及平行樣。加標回收率應控制在85%-115%，相對標準偏差（RSD）≤10%。
1. 樣品采集：活性炭管以0.5 L/min流量采集15分鐘；
2. 解吸處理：加入1 mL二硫化碳超聲解吸30分鐘；
3. 儀器分析：進樣量1 μL，分流比10:1，柱溫程序從50℃升至200℃。
1. 正己烷易揮發，采樣后需密封冷藏并于7天內分析；
2. 二硫化碳屬易燃有毒試劑，應在通風櫥內操作；
3. 需定期校驗色譜系統（保留時間偏差≤2%）。
以上信息僅供參考，請以相應標準的原文為準！