正己烷_(kāi)單標_有機類_標準物質_萘析商城_實驗室科技服務創新平臺

圖片僅供參考，具體產品以實物為準！

正己烷

BW901023

~~{{goodObj.price > 0 ? '￥' + goodObj.price : '咨詢'}}~~

￥{{goodObj.sell_price || 0}} 咨詢

110-54-3

1mL

秦境

98.5%

猜您喜歡

正己烷
BW901023 | 98.5%
正己烷
H109654-5L | AR, ≥97%
己烷
H431446-1L | ACS, 適用于分析
正己烷
SH-GC1103 | GCS
正己烷
R003803-4X4L | HPLC,≥98.0%

正己烷介紹：

Reference Material

This certificate is designed in accordance with ISO 17034 and ISO Guide 31. This reference material (RM) was designed,produced and verified in accordance with ISO/IEC 17025, ISO 17034 and a registered quality management system ISO9001.

Product Name	n-Hexane
Product Code	BW901023
Lot Number	23041530
CAS No.	110-54-3
Mol. Formula	C₆H₁₄
Mol. Weight	86.18
Certified on	18 Apr 2023
Expiry Date	17 Apr 2025
Storage Temp	(0~4)°C
Specification	1 mL

CERTIFIED

Purity

CERTIFIED

Expanded Uncertainty (U)

Approved by

98.5%

0.5%

Uncertainty

The certified value(s) and uncertainty(ies) are determined in accordance with ISO 17034 with an 95% confidence level (k=2). Uncertainty is based on the Total Combined Uncertainty, including uncertainties of characterisation, homogeneity and stability testing. Stability values are based on real evidence opposed to simulation.

The producer certifies that this reference material meets the specification stated in this certificate until the expiry date, provided it is stored unopened at the recommended temperature herein. Product warranties for this reference material are set out in the terms and conditions of purchase.

Intended Use

This RM is intended for use in a laboratory as a calibration and quality control standard or in method development for analytical techniques.

Safety

Proper precautions should be observed while handling. See Safety Data Sheet.

Traceability

The balances used for gravimetric measurements are calibrated with weights traceable to the national standards (DKD). The calibration of the balances is verified daily internally and annually by an external accredited calibration service. Chromatographic methods are traceable to the International System of Units (SI).

Homogeneity

Random replicate samples of the final packaged RM have been analysed to prove homogeneity compliant with ISO 17034.

Storage

The RM should be stored in the original sealed container at the indicated temperature.

Instructions for use

It is recommended to use 1 mg as the minimum sample size and if less material is used, to increase the certified uncertainty by a factor of two for half sample and four for a quarter of sample. If storage after opening is necessary, the RM should be tightly closed and kept from light and moisture. If the RM was in a sealed ampoule, it should be transferred to a vial with minimum head space.

您正在瀏覽的產品：正己烷

手機版：正己烷

本公司銷售的所有產品僅供實驗科研使用，不用于人體及臨床診斷。

1. 標準名稱及標準號

GBZ/T 160.37-2004
《工作場所空氣有毒物質測定烷烴類化合物》

2. 適用范圍

本標準適用于工作場所空氣中正己烷（CAS:110-54-3）濃度的測定，涵蓋采樣、前處理及氣相色譜分析全流程，包括職業接觸限值判定。

3. 核心檢測方法

活性炭管采樣-溶劑解吸-氣相色譜法（FID檢測器）。樣品經二硫化碳解吸后進樣分析，以保留時間定性，峰面積定量。

4. 檢出限與定量限

方法檢出限（LOD）為0.5 μg/mL（對應空氣濃度為0.25 mg/m3），定量限（LOQ）為1.5 μg/mL（對應空氣濃度為0.75 mg/m3）。

5. 質控樣品要求

每批次需包含空白樣品、平行雙樣和加標回收樣，加標回收率應在85%-110%，相對標準偏差（RSD）≤10%。

6. 關鍵實驗步驟

采樣: 活性炭管以0.5 L/min流量采集15 L空氣樣品
解吸: 二硫化碳浸泡解吸30分鐘，震蕩強化解吸效率
分析: 氣相色譜儀進樣，色譜柱推薦使用HP-5（30 m×0.32 mm×0.25 μm）

7. 特別說明

實驗室需驗證本底干擾，避免使用含烴類溶劑的耗材；采樣時需避開靜電環境，正己烷蒸氣密度大于空氣，建議在呼吸帶高度采樣。

以上信息僅供參考，請以相應標準的原文為準！