三氯乙烯_單標_有機類_標準物質_萘析商城_實驗室科技服務創新平臺

圖片僅供參考，具體產品以實物為準！

三氯乙烯

BW901003

~~{{goodObj.price > 0 ? '￥' + goodObj.price : '咨詢'}}~~

￥{{goodObj.sell_price || 0}} 咨詢

79-01-6

1mL

秦境

99.7%

猜您喜歡

三氯乙烯
BW901003 | 98.6%
三氯乙烯
BW901003 | 99.7%
三氯乙烯
H17400-5mL | >99.5%(GC)
三氯乙烯
H17400a | AR
三氯乙烯
R051613-500ml | AR,99.0%,含40ppm二異丙胺穩定劑

三氯乙烯介紹：

Method of Characterisation

GC/FID

Batch Information

Water Content: <0.1% (by Karl-Fischer-Titration)

Uncertainty

The certified value(s) and uncertainty(ies) aredetermined in accordance with ISO 17034 with an 95% confidence level (k=2).Uncertainty is based on the Total Combined Uncertainty, including uncertaintiesof characterisation, homogeneity and stability testing. Stability values are basedon real evidence opposed to simulation.

The producer certifies that this reference materialmeets the specification stated in this certificate until the expiry date,provided it is stored unopened at the recommended temperature herein. Productwarranties for this reference material are set out in the terms and conditionsof purchase.

Intended Use

This RM is intended for use in a laboratory as acalibration and quality control standard or in method development foranalytical techniques.

Safety

Proper precautions should be observed whilehandling. See Safety Data Sheet.

Traceability

The balances used for gravimetric measurements arecalibrated with weights traceable to the national standards (DKD). Thecalibration of the balances is verified daily internally and annually by anexternal7 accredited calibration service. Chromatographic methods are traceableto the International System of Units (SI).

Homogeneity

Random replicate samples of the final packaged RMhave been analysed to prove homogeneity compliant with ISO 17034.

Storage

The RM should be stored in the original sealedcontainer at the indicated temperature.

Instructions for use

It is recommended to use 1 mg as the minimum samplesize and if less material is used, to increase the certified uncertainty by afactor of two for half sample and four for a quarter of sample. If storageafter opening is necessary, the RM should be tightly closed and kept from lightand moisture. If the RM was in a sealed ampoule, it should be transferred to avial with minimum head space.

您正在瀏覽的產品：三氯乙烯

手機版：三氯乙烯

本公司銷售的所有產品僅供實驗科研使用，不用于人體及臨床診斷。

國家標準解讀（三氯乙烯相關）

標準名稱及標準號	GB/T 5750.8-2023《生活飲用水標準檢驗方法第8部分：有機物指標》
適用范圍	適用于生活飲用水中三氯乙烯及其他揮發性有機物的測定，包括水源水、出廠水和末梢水。
核心檢測方法	頂空氣相色譜法（HS-GC），采用毛細管色譜柱分離，ECD檢測器或MS檢測器定量。
檢出限與定量限	檢出限為0.1 μg/L，定量限為0.3 μg/L（依據儀器靈敏度調整）。
質控樣品要求	每批次需包含空白對照、平行樣及加標回收樣，加標量應為待測物濃度的0.5-2倍，回收率范圍85%-115%。
關鍵實驗步驟	1. 樣品采集后需冷藏避光保存并在7日內分析； 2. 頂空平衡溫度60℃±1℃，平衡時間30 min； 3. 色譜柱程序升溫，初始溫度40℃保持5 min，以10℃/min升至200℃。
特別說明	樣品中若存在四氯化碳等干擾物需通過色譜柱選擇或前處理消除，結果報告需注明是否扣除本底干擾。

標準名稱及標準號	HJ 639-2012《水質 揮發性有機物的測定吹掃捕集/氣相色譜-質譜法》
適用范圍	地表水、地下水、工業廢水和生活污水中三氯乙烯等54種揮發性有機物的檢測。
核心檢測方法	吹掃捕集前處理結合GC-MS分析，內標法定量，使用DB-5MS色譜柱（30 m×0.25 mm×1.4 μm）。
檢出限與定量限	三氯乙烯方法檢出限為0.02 μg/L，定量下限為0.08 μg/L。
質控樣品要求	每10個樣品需插入1個實驗室空白，平行樣相對偏差應≤20%，內標物回收率60%-130%。
關鍵實驗步驟	1. 樣品瓶需無頂空并密封，保存于4℃且48小時內分析； 2. 吹掃時間11 min，捕集阱溫度40℃； 3. 質譜掃描模式為全掃描（m/z 35-270）。
特別說明	高濃度樣品需稀釋后分析，若存在顆粒物需經0.45 μm濾膜過濾。

以上信息僅供參考，請以相應標準的原文為準！